Hiring Robotics Engineer Electronics And Embedded Hardware (Bengaluru)

Robotics Engineer;

Electronics and Embedded Hardware

Job description:

Role: Design and validate control, sensing and power electronics for Integras robotic arms, underwater manipulators and mobile robots, from schematic and PCB development through manufacturing and field integration.

Previous experience: 2+ years in embedded hardware or robotics electronics, with ownership of at least two custom PCB designs through fabrication, board bring-up, and validation on physical systems.

Qualification: B.E./B.Tech or M.Tech in Electronics, Electrical, Instrumentation, Mechatronics or a related discipline.

Work arrangement: Full time, work from office;

production and client site support with travel as required.

Scope of responsibilities:

• Design schematics and multilayer PCBs for MCU control, sensor acquisition, isolated I/O and power regulation;

review component derating, return paths, signal integrity and heat dissipation.

• Engineer power distribution, DC/DC conversion, current sensing and protection;

validate inrush, motor transients, reverse polarity, overcurrent and thermal behaviour.

• Integrate encoders, motor drives and sensors over CAN, RS485, Ethernet, SPI, I2C and UART as applicable;

define pinouts, grounding, shielding and harness requirements.

• Develop board support and diagnostic firmware in C/C++ using ADC, PWM, DMA, interrupts and watchdogs;

verify timing and timestamped sensor acquisition with the controls team.

• Bring up and debug boards using oscilloscopes, logic analysers and electronic loads. Resolve noise, resets, communication faults and thermal failures through measured tests.
• Implement hardware fault detection and interfaces to emergency stop and safety circuits;

verify specified responses to power, sensor and communication failures.

• Release BOMs, fabrication/assembly files and revisions;

develop production testfixtures, supplier acceptance checks and documented calibration and test procedures.

Software and technical experience:

Required proficiency: Altium Designer;

MCU development/debugging tools such as STM32CubeIDE or equivalent;

embedded C/C++, Git andPython for test automation.

Working knowledge: Fusion 360 for PCB and enclosure fit reviews.

Must have qualifications:

• Proven ownership of custom PCB development through board bring-up, measured validation and manufacturing release.
• Ability to justify component selection, power budgets and protection circuits with calculations, waveforms and test results.
• Practical C/C++ firmware and interface debugging, with demonstrated resolution of electrical or communication faults on physical hardware.

Preferred qualifications:

• Experience with BLDC/servo drive electronics, gate drivers, phase current sensing, encoder interfaces or field-oriented control.
• Experience with EMI/EMC testing, ESD protection, thermal validation and production test automation.
• Experience with sealed or underwater electronics, conformal coating, rugged connectors and corrosion or vibration exposure.

Required evidence of experience:

Share two non-confidential board examples with your role, schematics/layouts, bring-up results and a measured fault diagnosis and correction. .